Ride-On for MOPED

Op voorraad
SKU
1900.0000500-GB
€ 19,50

Don't let a flat tire stop you!

Special anti-leak formula prevents flat tires
Special formula for mopeds
Reduces tire wear and fuel consumption

Don't let a flat tire stop you!

With Ride-On in your tires you’re always safe on the road. You’ll benefit from:

  • Protection and safety: the special anti-leak formula prevents flat tires
  • Comfort: tires are balanced continuously for a smooth ride
  • Sustainability: Ride-On reduces tire wear and fuel consumption

This Ride-On formula was specially developed for tires of motoscooters. It automatically seals punctures caused by nails, thorns, glass, etc. up to 5mm in diameter within seconds and without noticeable pressure loss.

  • Ride-On for motoscooters and mopeds works during the entire lifespan of the tire, at least five years. It also lengthens the lifespan by 25%. 
  • Application is easy and quick. 

This product is not recommended for and SHOULD NOT BE USED in high-speed motorcycles, automobiles or any vehicle that will regularly travel at highway speeds.


Meer Informatie
Inhoud 2 x 250 ml + Tools
Schrijf je eigen review
Je reviewed:Ride-On for MOPED
Jouw rating

Installation Instructions

You’ll need

  • Air compressor
  • Scissors
  • Safety glasses 

Step 1. Rotate the tire so that the valve stem is positioned at 4 or 8 o’clock

If there is a cap covering the valve stem, remove it. 

Step 2. Remove the valve core

Place the provided valve core removal tool onto the valve and unscrew it by turning counterclockwise. This will allow you to remove the valve core and deflate the tire.

Step 3. Slide the provided hose onto the valve

Step 4. Place the hose onto the bottle

Take the cap off the Ride-On bottle. Cut the tip of the bottle at the indicated line so the gel can easily go through.

Attention: Make sure when you cut that the hose can still fit on the bottle tip.

Tip: If you prefer you can also place the bottle tip directly (without hose) on the valve.

Step 5. Squeeze the entire contents of the bottle into the tire.

Step 6. Use the compressor to put a bit of air into the tire

Injecting a short burst of air will clear the valve stem.

Step 7. Reinstall the valve core

Screw the valve core back in by turning it clockwise with the provided tool. Do not overtighten. Inflate the tire to the recommended pressure.

Tip: If you’re not sure about the right pressure, this can often be found on a sticker on the inside of the car door, the fuel cap or your car’s instruction manual.

Step 8. Repeat the steps for the other tires.

The tire is now successfully filled with Ride-On. Starting back at step 1, repeat the steps until all the tires have been treated.

When all tires have been successfully filled with Ride-On, it is time for the final step:

Step 9. Drive your vehicle so the Ride-On can spread evenly over the tire tread.

Drive 5 to 10 kilometers to allow Ride-On to spread sufficiently. You may experience a slight vibration at first, but this will wear off as you drive further and the formula spreads out.

Attention: Ride-On needs to be run in at every speed, so the vibrations may reoccur as you speed up. Eventually the Ride-On will coat the tires evenly and balance out.

If you have very large tires, we recommend you start off driving slowly. The Ride-On will need a bit more time to spread. 

Installation video